Recycling of Post-Consumer Waste Polystyrene Using Commercial Plastic Additives

Photothermal conversion can promote plastic depolymerization (chemical recycling to a monomer) through light-to-heat conversion. The highly localized temperature gradient near the photothermal agent surface allows selective heating with spatial control not observed with bulk pyrolysis. However, identifying and incorporating practical photothermal agents into plastics for end-of-life depolymerization have not been realized. Interestingly, plastics containing carbon black as a pigment present an ideal opportunity for photothermal conversion recycling. Herein, we use visible light to depolymerize polystyrene plastics into styrene monomers by using the dye in commercial black plastics. A model system is evaluated by synthesizing polystyrene–carbon black composites and depolymerizing under white LED light irradiation, producing styrene monomer in up to 60% yield. Excitingly, unmodified postconsumer black polystyrene samples are successfully depolymerized to a styrene monomer without adding catalysts or solvents. Using focused solar irradiation, yields up to 80% are observed in just 5 min. Furthermore, combining multiple types of polystyrene plastics with a small percentage of black polystyrene plastic enables full depolymerization of the mixture. This simple method leverages existing plastic additives to actualize a closed-loop economy of all-colored plastics.