3D Printing-Assisted versus Conventional Extracorporeal Fenestration Tevar for Stanford Type B Arteries Dissection with Undesirable Proximal Anchoring Zone: Efficacy Analysis

To compare the outcomes of two Thoracic Endovascular Aortic Repair (TEVAR) techniques of Left Subclavian Artery (LSA) reconstruction for Stanford Type B Aortic Dissection (TBAD) patients with undesirable proximal anchoring zone.We retrospectively reviewed 57 patients with TBAD who underwent either three dimensional (3D)-printing-assisted extracorporeal fenestration (n = 32) or conventional extracorporeal fenestration (n = 25) from December 2021 to January 2023. We compared their demographic characteristics, operative time, technical success rate, complication rate, secondary intervention rate, mortality rate, and aortic remodeling.Compared with the conventional group, the 3D-printing-assisted group had a significantly shorter operative time (147.84 ± 33.94 min vs. 223.40 ± 65.93 min, p < 0.001), a significantly lower rate of immediate endoleak (3.1% vs. 24%, p = 0.048) and a significantly higher rate of true lumen diameter expansion in the stent-graft segment (all p < 0.05), but a significantly longer stent graft modification time (37.63 ± 2.99 min vs. 28.4 ± 2.12 min, p < 0.001). There were no significant differences in other outcomes between the two groups (p > 0.05). The degree of false lumen thrombosis was higher in the stent-graft segment than in the non-stent-graft segment in both groups and the difference was statistically significant (X2 = 5.390, 4.878; p = 0.02, 0.027).Both techniques are safe and effective for TBAD with an undesirable proximal landing zone. The 3D-printing-assisted extracorporeal fenestration TEVAR technique has advantages in operative time, endoleak risk, and aortic remodeling, while the traditional extracorporeal fenestration TEVAR technique has advantages in stent modification.