Properties of laser cladding (NiCoCr)94Al3Ti3-cBN-hBN hard self-lubricating ceramic coating

Titanium alloy is an essential material for preparing aerospace engines because of its excellent performance. However, the poor wear resistance of titanium alloy restricts its further development as a critical engine material. This study aimed to use laser cladding and particle enhancement technologies to enhance the surface wear resistance of titanium alloy. (NiCoCr)94Al3Ti3+hBN, (NiCoCr)94Al3Ti3+cBN, and (NiCoCr)94Al3Ti3+hBN + cBN were prepared on the surface of titanium alloy, and the wear resistance mechanism of single-phase self-lubricating particles, single-phase hard particles, and self-lubricating and hard biphasic particles was investigated. The results showed that the microhardness of the biphase-reinforced coating was 1083.8 HV0.5, which was higher than that of the self-lubricating particle-reinforced coating and hard-particle-reinforced coating by 368.4 HV0.5 and 149.8 HV0.5, respectively. The friction coefficient of the biphase-reinforced coating was 0.4208, which was lower than that of the self-lubricating particle-reinforced coating and hard-particle-reinforced coating by 0.0224 and 0.0686, respectively. The wear rate of the biphase-reinforced coating was 0.076 mm3/NM, and the wear resistance of the biphase-reinforced coating was 3.42 and 1.37 times that of the self-lubricating particle-reinforced coating and hard-particle-reinforced coating, respectively. hBN relied on its own decomposition to promote the coating to present a layered unstable structure to achieve a wear reduction effect, cBN relied on its own hardness to resist wear and played a wear-resistant role, whereas biphase-reinforced coating had a hard wear resistance and formed a lubricating film to enhance the wear resistance of the coating. The comprehensive performance of the dual-phase wear-resistant coating reinforced by hard particles and self-lubricating particles was better than that of single-phase wear-resistant coating, providing a reference for developing wear-resistant coating integrating hardness and self-lubrication.