Controllable Interfacial Polymerization for Nanofiltration Membrane Performance Improvement by the Polyphenol Interlayer

It is a huge challenge to have a controllable interfacial polymerization in the fabrication process of nanofiltration (NF) membranes. In this work, a polyphenol interlayer consisting of polyethyleneimine (PEI)/tannic acid (TA) was simply assembled on the polysulfone (PSf) substrate to fine-tune the interfacial polymerization process, without additional changes to the typical NF membrane fabrication procedures. In addition, three decisive factors in the interfacial polymerization process were examined, including the diffusion kinetics of fluorescence-labeled piperazine (FITC-PIP), the spreading behavior of the hexane solution containing acyl chloride, and the polyamide layer formation on the porous substrate by in situ Fourier transform infrared (FT-IR) spectroscopy. The experimental results demonstrate that the diffusion kinetics of FITC-PIP is greatly reduced, and the spreading behavior of the hexane solution is also impeded to some extent. Furthermore, in situ FT-IR spectroscopy demonstrates that by the mitigation of this PEI/TA interlayer, the interfacial polymerization process is greatly controlled. Moreover, the as-prepared NF membrane exhibits an increased water permeation flux of 65 L m-2 h-1 (at the operation pressure of 0.6 MPa), high Na2SO4 rejection of >99%, and excellent long-term structural stability.