Preparation and electrochemical properties of a ceramic solid electrolyte with high ionic conductivity, Li1.3Al0.3Ti1.7(PO4)3

The emergence of lithium-ion solid electrolytes greatly increases the safety risk of liquid electrolytes. Among the many solid electrolytes, aluminum-doped Li1.3Al0.3Ti1.7(PO4)3(LATP) has become a research hotspot due to its high ionic conductivity and good air stability. However, the traditional high-temperature sintering process has the problems of lithium volatilization and secondary phase formation. Therefore, it is very difficult to prepare high-quality LATP solid electrolytes. The X-ray diffraction pattern and analysis showed that the LATP samples prepared in this paper showed rhombohedral structure and could be indexed by the R3c space group, and a new method of excess lithium compensation sintering was proposed, in which lithium compensation (LiNO3) could well reduce the impact of lithium volatilization. It can be used as a sintering additive to promote the sintering densification of LATP. In this paper, the optimal sample for sintering at 900°C was determined by measuring the microstructure and electrochemical properties of the electrolyte, and lithium doping was studied. The LATP solid electrolyte with 10 wt% lithium doped has a conductivity of 7.2× 10-4 S/cm and a low activation energy (0.278 eV). Its mechanical properties (elastic modulus and hardness) are the best, which are 103.024 GPa and 8.053 GPa, respectively, and the value of its elastic modulus is much greater than that of lithium metal shear modulus of 4.25 GPa, which can effectively inhibit the growth of lithium dendrites. And the magnitude of the grain boundary conductivity and particle size of the lithium-doped sample correspond to the dielectric constant results.