Brain Vasculature Color-Labeling Using the Triple-Injection Method in Cadaveric Heads: A Technical Note for Improved Teaching and Research in Neurovascular Anatomy

BACKGROUND: Color-labeling injections of cadaveric heads have revolutionized education and teaching of neurovascular anatomy. Silicone-based and latex-based coloring techniques are currently used, but limitations exist because of the viscosity of solutions used. OBJECTIVE: To describe a novel “triple-injection method” for cadaveric cranial vasculature and perform qualitative and semiquantitative evaluations of colored solution penetration into the vasculature. METHODS: After catheter preparation, vessel cannulation, and water irrigation of embalmed cadaveric heads, food coloring, gelatin, and silicone solutions were injected in sequential order into bilateral internal carotid and vertebral arteries (red-colored) and internal jugular veins (blue-colored). In total, 6 triple-injected embalmed cadaveric heads and 4 silicone-based “control” embalmed cadaveric heads were prepared. A qualitative analysis was performed to compare the vessel coloring of 6 triple-injected heads with that of 4 “control” heads. A semiquantitative evaluation was completed to appraise sizes of the smallest color-filled vessels. RESULTS: Naked-eye and microscope evaluations of embalmed experimental and control cadaveric heads revealed higher intensity and more distal color-labeling following the “triple-injection method” compared with the silicone-based method in both the intracranial and extracranial vasculature. Microscope assessment of 1-mm-thick coronal slices of triple-injected brains demonstrated color-filling of distal vessels with minimum diameters of 119 μm for triple-injected heads and 773 μm for silicone-based injected heads. CONCLUSION: Our “triple-injection method” showed superior color-filling of small-sized vessels as compared with the silicone-based injection method, resulting in more distal penetration of smaller caliber vessels.