Influence of temperature and relative humidity on the antifungal effect of 405 nm LEDs against Botrytis cinerea and Rhizopus stolonifer and their inactivation on strawberries and tomatoes

Abstract In recent years, photodynamic inactivation (PDI) has emerged as a promising preservation method to complement refrigeration in the fresh produce supply chain. However, due to infrastructural limitations in the supply chain, fresh produce is often exposed to environmental conditions rather than recommended storage conditions. Hence, this study aimed to investigate the influence of two important environmental variables in the fresh produce supply chain - temperature and relative humidity (RH), on the PDI of fruit spoilage molds. It also aimed to demonstrate proof-of-concept of their inactivation on fruit surfaces. In the in vitro stage, Botrytis cinerea and Rhizopus stolonifer, the two molds selected for this study, were illuminated with 405 nm LEDs on Dichloran Rose-Bengal Chloramphenicol (DRBC) agar at three levels of temperature (7, 16 and 25 °C) and relative humidity (40, 60 and 80%). Illumination under these conditions caused reductions greater than 94% in the mold populations, at all temperatures and relative humidities. Even so, a temperature of 25 °C was observed to be marginally better for the inactivation as compared to 7 and 16 °C, as it necessitated the lowest dose (6–7 kJ) for the first log reduction of both the molds. Similarly, an RH of 40% worked slightly better for the inactivation of B. cinerea, as it induced inactivation without any lag phase and required the lowest dose (8.03 kJ) for the first log reduction. When the antifungal effect was investigated on fruit surfaces, it was discovered that the illumination reduced the populations of B. cinerea and R. stolonifer on strawberries by 67% and 19%, whereas on tomatoes, the respective inactivations were 79% and 70% respectively. These results demonstrate further promise of PDI as a postharvest technology for reducing the risk of fruit spoilage. This study is also the first to demonstrate the potential of PDI to add value to supply chains where compliance to ideal storage conditions is not feasible.