Friction and corrosion characteristics of microarc oxidation/laser cladding palygorskite coating on 6061 aluminum alloy substrates

In this study, micro arc oxidation (MAO) technology was used to surface coating of 6061 aluminum (Al) disk. Then laser is used to clad palygorskite (Pal) on the surface of the MAO coating to improve the protection of the coating against the Al substrate. The laser irradiates heat onto the Pal powder, the Pal is heated and at the same time the MAO coating is affected by the heat, and the MAO coating is cooled and cured along with the Pal to form the MAO- Pal composite coating. The surface morphology, elemental composition and phase composition of the MAO-Pal coating were analyzed using scanning electron microscopy, energy spectroscopy and X-ray diffraction. And friction experiments were performed on the MAO- Pal coating. The results showed that the coefficient of friction (COF) of the MAO-Pal coating was reduced by 27 % compared to the Al substrate and 19 % compared to the MAO coating under water lubrication conditions. Through the corrosion resistance experiments, the corrosion potential (Ecorr) of the MAO- Pal coating increased by 0.197 V compared to the Al substrate and 0.280 V compared to the MAO coating, and the corrosion current density (Icorr) simultaneously decreased by three orders of magnitude compared to the Al substrate and one order of magnitude compared to the MAO coating. The MAO- Pal coating prepared by laser cladding Pal had good wear and corrosion resistance, which improved the service life and application range of Al alloy and was expected to promote the development of Al alloy in the application field.