The role of the number of filaments in the dissociation of CO2 in dielectric barrier discharges

Abstract An experimental investigation of the dissociation of CO 2 in a symmetric pin-to-pin dielectric barrier discharge (DBD) is presented. The reactor geometry allows for an accurate control of the number of filaments (microdischarges) and is used to study the impact of one single filament on the CO 2 dissociation. We show the number of filaments per half cycle follows a power-law as a function of the injected power and does not depend on pressure, flow or other process parameters. It is shown that for pressures between 200 and 700 mbar approximately 0.5 W per filament is required and the charge transferred per filament remains constant at 0.5 nC. Furthermore, the dependence of CO 2 conversion on only specific energy input (SEI) is shown to be valid down to a single filament. Additionally, by using quantum cascade laser absorption spectroscopy the absolute number of CO molecules produced per filament is measured and is found to be in the range from 5.10 11 to 2.10 12 . The conversion degree of CO 2 into CO is estimated to be lower than 0.1% within a single filament and increases with SEI. In the presence of a couple of filaments, the maximum energy efficiency obtained is 25%. A comparison of the conversion degrees in pin-to-pin DBD and plane-to-plane DBD configuration shows that these two reactor geometries follow the same power law. This means the geometry is not the most important parameter in CO 2 dissociation in DBDs, but the SEI and thus the number of filaments ignited per unit of time. This result means that the dependence of conversion degree on the SEI can be extended to a single filament. This observation leads to the conclusion that the SEI appears to be valid as a universal scaling parameter down to very low values.