Chemically converting residual lithium to a composite coating layer to enhance the rate capability and stability of single-crystalline Ni-rich cathodes

Single-crystalline Ni-rich cathodes express great potential in state-of-the-art lithium-ion batteries (LIBs), but they still suffer from severe surface reactions, sluggish kinetics and microcracks upon prolonged cycling. Coating is an efficient strategy, yet the smooth morphology and low surface energy make it difficult to obtain a high-quality coating layer. In addition, most of the coatings hinder the interfacial transport of Li+, which further exacerbates the inherent sluggish kinetics of the single-crystalline cathodes. Here, assisted by reactive wetting of the residual lithium, a phospholipid-like protective layer of AlPO4-Li3PO4 is successfully constructed on the single-crystalline LiNi0.8Co0.1Mn0.1O2 surface ([email protected]), in which the ionic conductor Li3PO4 accelerates interfacial Li+ transport and the amorphous AlPO4 relieves stress during cycling. The obtained composite [email protected] cathode shows excellent cycling stability (88.9% capacity retention after 200 cycles) and rate capability (160.8 mA h g−1 at 3 C). This bifunctional coating strategy provides a new avenue for surface modification and may accelerate the development of single-crystalline Ni-rich cathodes for next-generation LIBs.