Effect of Modifiers on the Microstructure of Rapidly Solidified AlSi10Mg Alloy

Abstract In this work, melt-spun ribbons of AlSi10Mg added with modifiers (Er, Sr, or nano-TiB 2 ) were produced to investigate the combined effect of modification and rapid solidification on eutectic Si. The resulting eutectic microstructures are more isotropic in comparison to that of the base alloy affecting the mechanical properties of the alloys. The modification of Si morphology and supersaturation caused by the modifiers were investigated by microscopy, X-ray diffraction, and differential scanning calorimetry. Compared to melt-spun AlSi10Mg, the eutectic Si network is finer and less continuous when Er or Sr is added, and disrupted with rounded crystals dispersed in the matrix when adding nano-TiB 2 . The level of supersaturation decreases in the order Er–nano-TiB 2 –Sr. A transition from columnar Al grains at the wheel side to finer equiaxed grains at the air side was found in the unmodified ribbon and in the one containing nano-TiB 2 by means of electron backscattered diffraction. The Er- and Sr-modified ribbons display equiaxed Al grains of constant size throughout their thickness. The average hardness obtained by nano-indentation tests was lower than that of AlSi10Mg. The less continuous Si network causes the hardness drop but provides more isotropic mechanical properties.