丁坝
刚度
传输(电信)
扭矩
振动
点(几何)
接触面积
接触分析
结构工程
接触力学
控制理论(社会学)
噪音(视频)
工程类
计算机科学
有限元法
材料科学
声学
电气工程
数学
控制(管理)
物理
复合材料
人工智能
图像(数学)
热力学
几何学
作者
Miguel Pleguezuelos,Miryam B. Sánchez,José I. Pedrero
标识
DOI:10.1016/j.apm.2021.03.051
摘要
The loaded tooth deflections, manufacturing deviations, and assembly errors on spur gears induce a delay on the driven gear respect to the driving gear, which is called loaded transmission error. This delay causes an earlier start of contact outside the pressure line, resulting in a mesh-in impact, which is an important source of noise and vibrations. To avoid or mitigate this mesh-in impact, profile modifications on the driven tooth tip are frequently used. The additional gap due to the profile relief delays the effective start of contact, and a suitable amount of relief sets the mesh-in point back to the theoretical inner point of contact, which prevents the mesh-in impact and ensures a smooth contact. However, as the loaded transmission error depends on the transmitted load, a specific amount of relief will be suitable only for a specific input torque. For higher transmitted load mesh-in impact will occur again, while for lower transmitted load the effective contact ratio will be reduced due to an excessive delay of the start of contact. Therefore, under variable load conditions it is not possible to adjust the start of contact to the theoretical inner point of contact, so mesh-in impact, smooth contact and reduction of contact ratio may alternatively occur. In this paper, a simple analytical model for the meshing stiffness, load sharing ratio and transmission error is presented for spur gears with profile modification under non nominal -or variable- load conditions.
科研通智能强力驱动
Strongly Powered by AbleSci AI