Preparation and characterization of water‐soluble polymers and their utilization in chromium sorption

ABSTRACT In this article, we study the sorption of chromium from aqueous solutions using water‐soluble polymers (WSPs): poly[2‐(acryloyloxy) ethyl] trimethylammonium chloride, P(ClAETA); poly[2‐(methacryloyloxy) ethyl] trimethylammonium methyl sulfate, P(SAETA); and poly(sodium 4‐styrenesulfonate), P(NaSS). These WSPs were obtained by radical polymerization and purified by fractionation through ultrafiltration membranes with different molar mass cut‐offs (30 and 100 kDa). The characterization was carried out by thermogravimetric analysis (TGA), FTIR, and 1 H‐NMR spectroscopies and scanning electron microscopy/energy dispersive X‐ray spectroscopy. The chromium retention properties of the polymers were determined in terms of pH, optimal polymer concentration, and the effect of interfering ions. The results show yields above 80% for all of the synthesized WSPs. Characterization by spectroscopy confirmed the chemical structure of the polymers. TGA shows thermal decomposition temperatures of 264 and 324 °C for P(ClAETA) and P(SAETA), respectively. In the case of P(NaSS), the first thermal decomposition begins at approximately 450 °C. Maximum retention of Cr(VI) (100%) by the polymers P(ClAETA) and P(SAETA) was achieved at pH 9, and the maximum retention of Cr(III) (100%) was achieved by P(NaSS) at pH 3. The optimal polymer:Cr molar ratio obtained was 20:1. The retention of chromium(VI) was decreased by the presence of interfering ions, and the hydrodynamic flux was almost constant during ultrafiltration. © 2017 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2017 , 134 , 45355.