材料科学
立方氧化锆
粘结强度
水泥
复合材料
蒸馏水
粘接剂
复合数
表面粗糙度
牙科粘接
胶粘剂
化学
陶瓷
图层(电子)
色谱法
作者
Merve Çakırbay Tanış,Canan Akay,Murat Şen
摘要
Abstract Objective To evaluate the shear bond strength of resin cements to zirconia treated with the selective infiltration etching technique (SIE). Materials and Methods Forty‐seven zirconia specimens were prepared with a sequence of silicon carbide abrasives, cleaned in an ultrasonic bath. Three samples were separated for atomic force microscope (AFM) analyses (one nontreated for control, one sandblasted, and one selective infiltration etched) and the remaining were randomly distributed in four groups, according to the combination of surface treatment and resin cement: group 1a (sandblasting + Variolink II), group 1b (sandblasting + Panavia SA Plus), group 2a (SIE + Variolink II), group 2b (SIE + Panavia SA Plus). A composite resin cylinder (3 mm × 3 mm) was cemented to the zirconia surface, as per each group's specific protocol. After storing 24 hours in distilled water at 37°C, the specimens were tested for shear bond strength and the results were subjected to statistical analysis. Results At 24 hours, the highest SBS values were observed in group 2b, where the SIE technique was used in conjunction with Panavia SA Plus. Lowest values were found in group 1a. Increased surface roughness was observed with SIE. Conclusions SIE significantly enhanced the resin bond strength to zirconia. However, cement selection was also an important factor, for both surface treatments tested. Clinical Significance Use of SIE method combined with MDP monomer containing resin cement can provide clinically acceptable bond strength between zirconia and resin cement .
科研通智能强力驱动
Strongly Powered by AbleSci AI