A positive-working photosensitive alkaline-developable polyimide with a highly dimensional stability and low dielectric constant based on poly(amic acid) as a polyimide precursor and diazonaphthoquinone as a photosensitive compound

A positive-working photosensitive polyimide precursor based on fluorinated poly(amic acid) (FPAA) and 2,3,4-tris(1-oxo-2-diazonaphthoquinon-4-ylsulfonyloxy)benzophenone (D4SB) as a photosensitive compound has been developed. FPAA was prepared by ring-opening polyaddition of dianhydrides, pyromellitic dianhydride and biphenyltetracarboxylic dianhydride, with diamine, 2,2′-bis(trifluoromethyl)benzidine, in methanol. The FPAA film showed excellent transparency to UV light and good solubility in a wide range of organic solvents. The dissolution behavior of FPAA containing 30 wt % D4SB after exposure was studied, and it was found that the difference of dissolution rate between exposed and unexposed parts was enough to get high contrast due to the photochemical reaction of D4SB in the polymer film. The photosensitive fluorinated polyimide (FPI) precursor containing 30 wt % D4SB showed a sensitivity of 80 mJ cm−2 and a contrast of 7.8 with 365 nm light when it was developed with 0.3% aqueous tetramethyl ammonium hydroxide solution at room temperature. The FPI film cured up to 360°C had a low coefficient of thermal expansion of 10.3 ppm °C−1 and a low dielectric constant of 3.04. © 1998 John Wiley & Sons, Inc. J. Polym. Sci. A Polym. Chem. 36: 2261–2267, 1998