An alternative Rayleigh wave excitation method using an ultrasonic phased array

Ultrasonic Rayleigh waves have been employed for in-service NDT inspection in a wide range of industries for years. The excitation of Rayleigh waves can be achieved using a variety of methods, with the so-called wedge technique being the most widely used. Recent years have seen considerable research interest in surface crack detection and sizing using Rayleigh waves excited and detected with the wedge technique. However, in this method, Rayleigh waves experience transmission loss at the wedge interfaces. Moreover, the flexibility to generate Rayleigh waves on different waveguides using the same wedge is limited, as the wedge angle depends on the Rayleigh wave wavelength. This work demonstrates a method that provides an alternative Rayleigh wave excitation method. In this, a conventional ultrasonic phased array transducer is used. As there is an appropriate excitation delay between each piezoelectric element of the array transducer, Rayleigh waves can be generated in a wide range of materials using the same phased array transducer. The delay can be estimated based on the elementary pitch of the transducer and the Rayleigh wave velocity of the waveguide. The proposed Rayleigh wave excitation method is demonstrated through both experiments and FE simulations. Furthermore, a finite element model is used to better understand the features of the generated waves and to validate them through their characteristics as Rayleigh wave. A quantitative comparison between the proposed and existing methods is also presented. The directivity and beam divergence of the generated Rayleigh waves are quantified. The results obtained from experiments are in agreement with finite element simulations and demonstrate the possibility of unidirectional and selective excitation of Rayleigh waves through the proposed method. They also highlight the potential for this new excitation method to be used to develop new Rayleigh wave-based inspection methods.