Microstructural characterisation of creep tested advanced austenitic stainless steel super 304H

Microstructural characterisation was performed on the gauge section of two creep rupture samples manufactured from Super 304H; an advanced austenitic stainless steel that is used as superheater and reheater tubes in power plants. The samples had been exposed to uniaxial creep tests (Sample A: 700°C and 75Mpa, Sample B: 650°C and 120Mpa) where both exhibited low creep ductility. Six phases were identified: MX (Nb-rich), sigma, Cu-rich, M23C6, modified Z phase and Fe (BCC). Quantification of Nb-rich and Cu-rich particles revealed ~10% and ~16% more Nb-rich and Cu-rich particles respectively in Sample A versus Sample B. The amount of sigma and the average particle size for the Nb and Cu-rich particles was similar for both samples. There appears to be an association between the sigma phase and creep cavities as shown in 2D microstructural characterisation which could have contributed to the low creep ductility exhibited by these two creep samples.