Fabrication of Steady Junctions Consisting of α,ω-Bis(thioacetate) Oligo(p-phenylene vinylene)s in Nanogap Electrodes

For obtaining molecular devices using metal−molecule−metal junctions, it is necessary to fabricate a steady conductive bridge-structure; that is stable chemical bonds need to be established from a single conductive molecule to two facing electrodes. In the present paper, we show that the steadiness of a conductive bridge-structure depends on the molecular structure of the bridge molecule for nanogap junctions using three types of modified oligo(phenylene vinylene)s (OPVs): α,ω-bis(thioacetate) oligo(phenylene vinylene) (OPV1), α,ω-bis(methylthioacetate) oligo(phenylene vinylene) (OPV2), and OPV2 consisting of ethoxy side chains (OPV3). We examined the change in resistance between the molecule-bridged junction and a bare junction in each of the experimental Au−OPV−Au junctions to confirm whether molecules formed steady bridges. Herein, the outcomes of whether molecules formed steady bridges were defined in terms of three types of result; successful, possible and failure. We define the ratio of the number of successful junctions to the total number of experimental junctions as successful rate. A 60% successful rate for OPV3 was higher than for the other two molecules whose successful rates were estimated to be ∼10%. We propose that conjugated molecules consisting of methylthioacetate termini and short alkoxy side chains are well suited for fabricating a steady conductive bridge-structure between two facing electrodes.