钩虫贪铜菌
聚-3-羟基丁酸酯
生物高聚物
大肠杆菌
羟基烷酸
食品科学
化学
碳纤维
作文(语言)
析因实验
雷斯顿
水解
拉伤
淀粉
重组DNA
基质(水族馆)
细菌
生物化学
材料科学
有机化学
酶
生物
聚合物
基因
哲学
数学
生态学
语言学
复合数
复合材料
遗传学
统计
解剖
作者
Gustavo Graciano Fonseca,Juliana Carvalho de Arruda-Caulkins,Regina Vasconcellos Antônio
标识
DOI:10.1177/0734242x07088443
摘要
Although the biopolymer poly-(3-hydroxybutyrate), P[3HB], presents physicochemical properties that make it an alternative material to conventional plastics, its biotechnological production is quite expensive. As carbon substrates contribute greatly to P[3HB] production cost, the utilization of a cheaper carbon substrate and less demanding micro-organisms should decrease its cost. In the present study a 2 3 factorial experimental design was applied, aiming to evaluate the effects of using hydrolysed corn starch (HCS) and soybean oil (SBO) as carbon substrates, and cheese whey (CW) supplementation in the mineral medium (MM) on the responses, cell dried weigh (DCW), percentage P[3HB] and mass P[3HB] by recombinant Escherichia coli strains JM101 and DH10B, containing the P[3HB] synthase genes from Cupriavidus necator (ex- Ralstonia eutropha). The analysis of effects indicated that the substrates and the supplement and their interactions had positive effect on CDW. Statistically generated equations showed that, at the highest concentrations of HCS, SO and CW, theoretically it should be possible to produce about 2 g L — 1 DCW, accumulating 50% P[3HB], in both strains. To complement this study, the strain that presented the best results was cultivated in MM added to HCS, SBO and CW (in best composition observed) and complex medium (CM) to compare the obtained P[3HB] in terms of physicochemical parameters. The obtained results showed that the P[3HB] production in MM (1.29 g L —1 ) was approximately 20% lower than in CM (1.63 g L — 1 ); however, this difference can be compensated by the lower cost of the MM achieved by the use of cheap renewable carbon sources. Moreover, using differential scanning calorimetry and thermogravimetry analyses, it was observed that the polymer produced in MM was the one which presented physicochemical properties ( T g and T f ) that were more similar to those found in the literature for P[3HB].
科研通智能强力驱动
Strongly Powered by AbleSci AI