Lithium Dendrite Propagation in Ta-Doped Li7La3Zr2O12 (LLZTO): Comparison of Reactively Sintered Pyrochlore-to-Garnet vs LLZTO by Solid-State Reaction and Conventional Sintering

Ta-doped Li₇La₃Zr₂O₁₂ (LLZTO) garnet is a promising Li-ion-conducting ceramic electrolyte for solid-state batteries. However, it is still challenging to use LLZTO in Li metal batteries operating at high current densities because of the tendency for Li metal to nucleate and propagate along the grain boundaries. In this study, we carry out a detailed investigation to elucidate the effect of microstructure and grain size on the electrochemical properties and short circuit behavior in LLZTO. Pellets were prepared using reactive sintering from pyrochlore precursors (a method called pyrochlore-to-garnet, P2G) and compared with LLZTO synthesized using solid-state reaction (SSR) followed by conventional pressureless sintering. Both preparation methods were controlled to keep the phase and elemental composition, ionic and electronic conductivity, relative density, and area-specific resistance of the pellets constant. Reflection electron energy loss spectroscopy and X-ray photoelectron spectroscopy confirm that both types of LLZTO have similar band gaps and chemical states. Microstructure analysis shows that the P2G method results in LLZTO with an average grain size of around 3 μm, which is much smaller than the grain sizes (as large as 20 μm) seen in SSR LLZTO. Galvanostatic Li stripping/plating and linear sweep voltammetry measurements show that P2G LLZTO can withstand higher critical current densities (up to 0.4 mA/cm² in bidirectional cycling and >1 mA/cm² for unidirectional) than those seen in SSR LLZTO. Post-mortem examination reveals much less Li deposition along the grain boundaries of P2G LLZTO, particularly in the bulk of the pellet, compared to SSR LLZTO after cycling. The improved cycling behavior in P2G LLZTO despite the higher grain boundary area could be from more homogeneous current density at the interfaces and different grain boundary properties arising from the liquid-phase, reactive sintering method. These results suggest that the effect of grain size on Li dendrite propagation in LLZO may be highly dependent on the synthesis and sintering method employed.