Design of shaped piezoelectric modal sensors for cantilever beams with intermediate support by using differential transformation method

In this paper a solution to the problem of finding the shape of piezoelectric modal sensors for a cantilever beam with intermediate support is proposed by using the differential transformation method (DTM). A general expression for designing the shape of a piezoelectric modal sensor is presented, in which the output signal of the designed sensor is proportional to the response of the target mode. Other modes are filtered out. The modal sensor shape is expressed as a linear function of the second spatial derivative of the structural mode shape function. By using boundary condition and continuity condition equations at intermediate support, the closed-form series solution of the second spatial derivative of the mode shapes can be determined based on DTM. Then the shapes of the designed modal sensors are obtained. Finally, numerical examples are given to demonstrate the feasibility of the proposed modal sensors for the cantilever beam with intermediate support.