Algorithms for time synchronization of wireless structural monitoring sensors

Dense networks of wireless structural health monitoring systems can effectively remove the disadvantages associated with current wire-based sparse sensing systems. However, recorded data sets may have relative time-delays due to interference in radio transmission or inherent internal sensor clock errors. For structural system identification and damage detection purposes, sensor data require that they are time synchronized. The need for time synchronization of sensor data is illustrated through a series of tests on asynchronous data sets. Results from the identification of structural modal parameters show that frequencies and damping ratios are not influenced by the asynchronous data; however, the error in identifying structural mode shapes can be significant. The results from these tests are summarized in Appendix A. The objective of this paper is to present algorithms for measurement data synchronization. Two algorithms are proposed for this purpose. The first algorithm is applicable when the input signal to a structure can be measured. The time-delay between an output measurement and the input is identified based on an ARX (auto-regressive model with exogenous input) model for the input–output pair recordings. The second algorithm can be used for a structure subject to ambient excitation, where the excitation cannot be measured. An ARMAV (auto-regressive moving average vector) model is constructed from two output signals and the time-delay between them is evaluated. The proposed algorithms are verified with simulation data and recorded seismic response data from multi-story buildings. The influence of noise on the time-delay estimates is also assessed. Copyright © 2004 John Wiley & Sons, Ltd.