Microstructure evolution of carbon films, grown by physical vapor deposition, when substrate temperature is increased

We study how the increases of substrate temperature influence the structural properties of carbon films deposited by physical vapor deposition (PVD) techniques. We installed and adapted a heating system inside the deposition chamber, which can reach temperatures as high as 700 °C. Here we develop an experimental setup that allows us to obtain large films of the desired material on any substrate, with deposition times of the order of a minute. The characterization is based mainly on the analysis of the Raman spectra, where the evolution of the G and D peaks corresponding to the material in its amorphous phase is observed. With the increase of substrate temperature, the sp2 zones grow. A displacement to the right of the G peak and an increase in the ID/IG ratio is seen. At 700 °C a 2D zone at a frequency greater than 2000 cm−1 appears. Four Lorentzian-shaped bands are necessary to account for the peaks at this zone, whose centers correspond to different combinations of first-order ones. This shows that we are transitioning from an amorphous to a carbon phase with more ordered or graphitic zones and that we are near the crystallization point. This opens the path to produce structures similar to graphene using this method of deposition. The Tauc gap energy ratio decreases as temperature increases indicating that there is a graphitization of the sample. Transmission FTIR study is carried out at some of the intermediate temperatures, determining the type of bond at low frequencies. These bonds are consistent with the ones of the hydrogenated amorphous carbon (a-C:H) structure.