Global study on slope instability modes based on 62 municipal solid waste landfills

This study summarized global examples of landfill slope instability over the past 40 years, then selected 62 cases from 22 different counties to analyse the primary factors causing landfill instability. Three slope instability modes in landfill were categorized according to the position of the slip surface: (1) slip surfaces generated inside the waste pile; (2) slip surfaces that pass through the foundation soil; and (3) slip surfaces that occur along the interface between the bottom liner and the municipal solid waste (MSW) pile. These three types of slope instability modes account for 69.4%, 19.32% and 11.28% of all slope instability, respectively. Moreover, five primary causes of landfill instability were identified. A high landfill leachate level was the dominant cause, accounting for 40.32% of cases. This was followed by inadequate compaction of MSW, which accounted for 22.58% of cases, and insufficiently bearing capacity of the foundation, which accounted for 19.35% of cases. Moreover, low shear strength of the liner–MSW interface and rapid release or deflagration of landfill gas were critical factors affecting landfill stability. Factors of safety were calculated using GeoStudio software for selected landfills in China (Maoershan and Xiaping) and Sri Lanka (Meethotamulla). Results from this study are expected to contribute to the prevention and control of landfill failure.