Experimental study on fluid flow behaviors of waterflooding fractured-vuggy oil reservoir using two-dimensional visual model

The carbonate reservoir plays a pivotal role in conventional oil and gas reservoirs. However, due to limited knowledge of fluid flow characteristics in fractured-vuggy carbonate formations (vuggy means a small to medium-sized cavity inside rock), high efficiency reservoir development remains challenging. In this study, the similarity principle is utilized to design a two-dimensional visual model based on geological data and the injection-production characteristics of a fractured-vuggy reservoir in M Oilfield. To investigate the characteristics of oil–water flow, the oil–water interface, and residual oil distribution, flooding experiments are conducted at various injection-production positions, types, and injection rates. The results suggest that a low injection/high production strategy is optimal for achieving maximum oil recovery. As a consequence, this configuration is employed in the subsequent flooding experiments. The optimal oil recovery of 82.2% is attained via pore injection and vug production. The Jamin effect exerts an influence on the oil-water flow in structures connected by small channels at the bottom of large vugs, necessitating adjustment of the flow rate to achieve optimal injection conditions. The variation of the oil–water interface height in each vug due to structural flaws results in suboptimal overall oil recovery. The oil recovery is limited to approximately 30% at an injection rate below 8 ml/min but can be enhanced to over 70% with a higher injection rate exceeding 8 ml/min. The residual oil of the fractured-vuggy reservoir is typically found in the tops of structures and peripheral areas with poor connectivity. The findings of this study offer direction for optimal production in fractured-vuggy carbonate reservoirs and facilitate a more comprehensive comprehension of oil–water flows within the reservoir.