材料科学
冶金
镁
焊接
激光束焊接
激光束
激光器
光学
物理
作者
A. Punkari,D. C. Weckman,H. W. Kerr
标识
DOI:10.1179/136217103225005516
摘要
The effects of Mg content on the weldability of aluminium alloy sheet using the dual-beam Nd:YAG laser welding process have been studied by making bead-on-plate welds on 1.6 mm thick AA 1100, AA 5754 (3.2 wt-%Mg) and AA 5182 (4.6 wt-%Mg) alloy sheets. Whereas all full-penetration laser welds made in 1100 aluminium were of excellent quality,many of the welds produced in the aluminium–magnesium alloys exhibited rough, spiky underbead surfaces with drop-through and undercut. A limited range of process variables was found, however, that allowed welds with acceptable weld bead quality to be produced in the 5754 and the 5182 alloy sheet. Goodwelds were only produced in these alloys if the lead/lag laser beam power ratio was ≥1. Weld penetration and the maximum welding speed allowing full penetration keyhole-mode welding were observed to increase with Mg content. This was attributed to the effect of Mg on the vapour pressure within the keyhole and the surface tension of the Al–Mg alloys. Significant occluded vapour porosity was seen in the 5754 and 5182 alloy welds with borderline penetration; however, there was no evidence of porosity in the acceptable full-penetration welds with smooth underbead surfaces. Hardness profiles in the 5754 and 5182 welds showed a gradual increase in hardness from the base metal values through the heat affected zone (HAZ) to a peak in hardness in the weld metal adjacent the fusion boundary. It is possible that this increase in hardness may be the result of the presence of Mg 2 Al 3 or metastable Mg 2 Al 3 ′ precipitates in this region of the weld and HAZ.
科研通智能强力驱动
Strongly Powered by AbleSci AI