Novel Placement of Cortical Bone Trajectory Screws in the Lumbar Spine

This is a radiographic and cadaveric study.The aim of this study was to conduct a detailed comparison about the parameters between the ideal cortical bone trajectory (CBT) and practical CBT screw.CBT screws have recently become popular in spinal surgery, mainly because of their improved fixation while minimizing soft tissue dissection. However, to our knowledge, no previous study has provided a detailed comparison on the parameters between the ideal CBT and practical CBT screws.The 3-dimensional computed tomography scans of 126 spinal vertebrae separated from 40 lumbar spines were studied. After determining the CBT, the maximal screw length, maximal screw diameter, lateral angle (LA), and cephalad angle (CA) were calculated. Thereafter, CBT screws were inserted into these cadaveric lumbar spines. Subsequently, the lateral angle of screw (LAs) and cephalad angle of screw (CAs) of the screws were measured using 3-dimensional computed tomography.As for the ideal CBT, the maximal screw length gradually increased from L1 (32.0 mm) to L4 (35.3 mm) and then decreased at L5 (34.8 mm). Moreover, the maximal screw diameter increased from L1 (4.5 mm) to L5 (7.5 mm). The LA from L1 to L5 were 9.2, 9.4, 9.9, 11.2, and 12.0 degrees, respectively. The CA from L1 to L5 were 25.8, 25.8, 26.3, 26.8, and 26.0 degrees, respectively. As for the actual CBT screw, the LAs from L1 to L5 were 12.7, 14.1, 13.2, 12.4, and 13.0 degrees, respectively. The CAs from L1 to L5 were 25.4, 27.5, 29.2, 30.1, and 30.5 degrees, respectively. Significant differences were observed between the angles of the ideal trajectory and the actual screw.Parameters of the actual CBT screw are slightly larger than the optimal trajectory measurements. The CAs and LAs are ∼25-30 and 10-16 degrees, respectively. L1 and L2 should be given considerable attention when using the CBT technique. And the trajectory measurements can only be used as a guide in clinical practice.