Flocculation of emulsified oily wastewater by using functional grafting modified chitosan: The effect of cationic and hydrophobic structure

In this work, modified chitosan flocculants (MCS) was synthesized by using chitosan (CS), acrylamide, cationic monomers and hydrophobic monomers via low-pressure UV-initiated copolymerization. The flocculation performance of MCS was evaluated in emulsified oily wastewater treatment. The effect of cationic and hydrophobic structure on oil removal was studied, and the interactions between these functional groups and the components in oil were also analyzed. Results suggested that MCS flocculants exhibited excellent oil removal efficiency in a wide pH range (2.0‒10). The flocculation efficiency of 91 % was achieved at the dosages of 0.6 mL/L (6 mg/L). During pH of 2.0-10, the optimal cationic and hydrophobic monomer was DMC and VT, respectively. Silane groups were favorable for oil removal than the other hydrophobic structures. The cationic groups expanded the optimal pH range of MCS in flocculation, whereas hydrophobic groups considerably reduced the dosage of MCS. The experimental results showed that alkane, cyclic aromatic hydrocarbon compounds in oil can be easily removed by using MC4, whereas cycloalkanes compounds was effectively removed by MC6 and MC7 because of preferable demulsification capacity, and the hydrophobic interaction, interfacial adsorption and electrostatic attraction played the dominant in flocculation. Thus, the synthesized MCS is favorable for emulsified oily wastewater treatment.