Reducing stress corrosion cracking susceptibility of high-strength aluminum alloy and its fastener by a novel electromagnetic shocking treatment

A novel electromagnetic shocking treatment (EST) is put forward to reduce the stress corrosion cracking (SCC) susceptibility of high-strength aluminum alloys and its fasteners by selectively modifying grain boundary (GB) microstructure. The effect of EST on the microstructure, mechanical properties and SCC susceptibility of T73-Al7075 alloy and its high-lock nuts has been investigated. Mechanical properties, electrochemical performance and constant strain SCC test have been carried out for T73-Al7075 alloy, microhardness test and SCC test under wet-dry cyclic condition have been carried out for its high-lock nuts, as well as microstructure characterizations via SEM, EBSD and TEM have been carried out for T73-Al7075 alloy. Comparing to the received sample, the strength of EST sample basically keep consistent while the elongation increases slightly, besides, the electrical conductivity and electrochemical corrosion performance improves. The SCC susceptibility of T73-Al7075 alloy and its high-lock nuts have been reduced after EST. Microstructure characterization shows that the grain morphology and matrix intragranular precipitate distribution of the EST sample keep almost the same as those of the received sample, which is consistent with the almost unchanged mechanical properties of alloy sample. However, EST induces the transformation of grain boundary precipitates (GBPs) and the formation of stripy/wavy GB as observed experimentally, which indicates that EST promotes nonlinear GB wetting or pre-melting and even grain bridging. The phase transformation and GB complexion transition induced by EST are main factors attributing to the obvious improvement of SCC resistance of T73-Al7075 alloy and its high-lock nuts. It can be deduced that anodic dissolution cracking will be relieved because of the dissolution and coarsening of GBPs. Hydrogen induced cracking and crack propagation can be relieved with the occurrence of grain bridging. They are both beneficial to improve SCC resistance of Al7075 alloys. This work provides a novel EST method to targetedly embellish GB microstructure, optimize GB complexion and connectivity, and then enhance the service performance of solid alloys and even finished parts.