Additive manufacturing of polymer‐derived ceramic matrix composites

Abstract This study presents a fabrication method and identifies processing bounds for additively manufacturing (AM) ceramic matrix composites (CMCs), comprising a silicon oxycarbide (SiOC) ceramic matrix. A digital light projection printer was used to photopolymerize a siloxane‐based preceramic resin containing inert ceramic reinforcement. A subsequent pyrolysis converted the preceramic polymer to SiOC. Particle reinforcements of 0 to 40% by volume in the green state were uniformly dispersed in the printed samples to study their effects on pyrolysis mass loss and shrinkage, and CMC notch sensitivity and strength. Both particle and whisker reinforcements toughened the glassy SiOC matrix (1 MPa m 1/2 ), reaching values >3 MPa m 1/2 . Bending strengths of >300 MPa (>150 MPa (g cm −3 ) −1 ) and a Weibull modulus of 10 were measured on AM samples without surface finish. We identified two pore formation mechanisms that placed processing bounds on sample size and reinforcement volume fraction. Methods for increasing these bounds are discussed. With properties commensurate to traditionally processed technical ceramics, the presented process allows for free‐form fabrication of high‐performance AM CMC components.