Improving interfacial strength at room and elevated temperatures in ultrasonic welding of pure titanium: Interlayer-induced phase transformation and concentrated plastic deformation

Ultrasonic welding (USW) of Titanium (Ti) sheets presents several challenges, notably crack formation due to sliding friction. To overcome this problem, the present study applied USW to pure α-Ti sheets both with and without different interlayer metals (Al, Ni, and Fe). Al interlayer improved the strength at room temperature significantly to cause base metal fracture (1700 N) by inducing concentrated plastic deformation, facilitating bonding with Ti while minimizing damage. However, its strength decreased significantly at 150–300 °C, suggesting the limitation of using Al interlayer at elevated temperatures. Conversely, the Ni and Fe interlayers led to a two-phase strength development. This enhancement was due to β-phase transformation, which reduces the interfacial defects and generates a more pronounced β-stabilization effect. The Ni interlayer, which has a higher β-transus point (765 °C) and lower molybdenum equivalency, required a higher welding energy (1800 J) and longer diffusion time into Ti, resulting in a gradual increase in strength due to a slower β-Ti transformation. On the other hand, the Fe interlayer with a lower β-transus point relative to Ti (595 °C) achieved peak strength at a lower welding energy of 1200 J. Both Fe and Ni interlayers displayed only a slight decrease in strength (1500–1600 N) at 300 °C with base metal fracture, revealing better joint performance at higher temperatures. These insights suggest a strategical interlayer selection based on the operation temperature, where Al interlayers were advantageous for low-energy welding at room temperature application, Fe and Ni interlayers offer sufficient strength at elevated temperatures by facilitating the β-Ti formation.