Identifying Areas of Screw Fixation in Glenoids with Severe Bone Loss in Shoulder Arthroplasty

Severe glenoid bone loss (SGBL) poses significant technical challenges. Adequate fixation of glenoid implants may require the use of alternative screw placement. Although bone volumes for the spine and lateral pillars have previously been defined, insufficient evidence exists regarding the distribution of screw placement for fixation in such regions for cases with SGBL. The purpose of this study is to evaluate the variability of screw placement. We hypothesize that determining this variability and establishing common patterns of glenoid bone loss will allow for recommendations for preoperative planning, and implant design and selection.An internal registry of 2 high-volume shoulder and elbow surgeons was queried, and 65 three-dimensional scapulae models exhibiting SGBL were identified. A fellowship-trained shoulder and elbow surgeon simulated the placement of two 3.5 mm × 30 mm screws, one in the scapular spine (CS) bone volume and one in the inferior column (IS) bone volume. Three orthogonal reference planes were created using anatomic reference points: the scapula trigonum, estimated glenoid center, and inferior pole. Screw positions were mapped, and deviations from the reference planes were calculated. Mutual positions of the IS to CS were also computed. Intraobserver reliability was assessed using 10 randomly selected samples. Median and 25th and 75th percentiles were reported for screw orientation distributions. Means and standard deviations were reported for screw head positions.We demonstrated excellent intraobserver reliability (intraclass correlation coefficients, 0.90-0.98). Fifty percent of CS were oriented 10° ± 5° of retroversion from the scapula plane, with 5° ± 5° of inclination. For IS, 50% were positioned 0° ± 4° from the scapula plane, with -33° ± 7° of inclination. The relationship of the IS with the CS was medial and posterior in 49% of cases, lateral and posterior in 45%, and lateral and anterior in 6% of cases. On average, the distance between the CS and IS heads was 25 mm ± 4 mm.For SGBL, adequate fixation of glenoid implants can be achieved by placing screws in the spine and lateral columns, with excellent reproducibility. Future implant designs should accommodate CS positioned -16° to -5° from the scapula plane, with 0° to 12° of inclination, and IS positioned -6° to 4° from the scapula plane, with -40° to -25° of inclination. Moreover, mutual screw positions suggested bone loss distributions anteriorly and inferiorly. Future implant designs should consider the potential benefits of augmentation to accommodate interscrew distances of 21-29 mm and anatomic locations of the IS relative to the CS.