The effect of ferrite–martensite morphology on the scratch and abrasive wear behaviour of a dual phase construction steel

A systematic experimental investigation concerning the effect of ferrite–martensite morphology on the scratch and abrasion resistance of ferrite–martensite dual phase (DP) steels is reported. A hot rolled 22MnB5 steel was subjected to different heat treatments to generate dual phase microstructures with different ferrite–martensite morphologies. The effects of morphology on the scratch resistance and the corresponding failure mechanisms were unravelled using a multi-pass dual-indenter (MPDI) scratch test applying different load combinations. Results show that the ferrite–martensite morphology has a significant influence on scratch resistance and that the effect is contact load dependent. The scratch behaviour is linked to the strength coefficient K in the Hollomon model (σ=Kεn) as well as the initial indentation hardness. Results suggest that the strength coefficient K corresponds well with the scratch resistance. The optimal microstructure to yield the best combination of abrasion resistance and hardness depends on the working conditions. At a low loading condition the relative ranking of the scratch resistance of the various microstructures created is in good agreement with that of the ASTM G65 abrasion test.