Preparation and characterization of ultrafine electrospun polyacrylonitrile fibers and their subsequent pyrolysis to carbon fibers

Abstract The present contribution reports the fabrication and characterization of ultrafine polyacrylonitrile (PAN) fibers by electrospinning and further development of the as‐spun PAN fibers into ultrafine carbon fibers. The effects of solution conditions (i.e., solution concentration, viscosity, conductivity, and surface tension) and process parameters (i.e., applied electrostatic field strength, emitting electrode polarity, nozzle diameter, and take‐up speed of a rotating‐drum collector) on morphological appearance and average diameter of the as‐spun PAN fibers were investigated by optical scanning (OS) and scanning electron microscopy (SEM). The concentration, and hence the viscosity, of the spinning solutions significantly affected the morphology and diameters of the as‐spun PAN fibers. The applied electrostatic field strength and nozzle diameter slightly affected the diameters of the as‐spun fibers, while the emitting electrode polarity did not show any influence over the morphology and size of the as‐spun fibers. Utilization of the rotating‐drum collector enhanced the alignment of the as‐spun fibers. Within the investigated concentration range, the average diameter of the fibers ranged between 80 and 725 nm. Finally, heat treatment of the as‐spun fibers with their average diameter of about 450 nm was carried out at 230 and 1000 °C, respectively. Various characterization techniques revealed successful conversion into carbon fibers with an average diameter of about 250 nm. Copyright © 2006 Society of Chemical Industry