Calcium hydroxy phosphate-functionalized graphene oxide/Nafion composite membrane for direct methanol fuel cell

A direct methanol fuel cell (DMFC) is one prominent alternative energy technology. However, there are many problems that prevent the commercialization of DMFC, such as methanol crossover, low power density, and degradation of the membrane. To resolve these issues, functionalized graphene oxide (GO) and calcium hydroxy phosphate (CHP) were incorporated into the Nafion membrane to make a composite membrane. The content of the CHP was varied to determine and further investigation involved spraying the same amount of CHP onto the Nafion membrane to compare with the composite membrane. The fillers were characterized using Fourier-transform infrared spectroscopy and X-ray Powder Diffraction. The ex-situ tests investigated water uptake, solubility, and chemical degradation, while the in-situ tests investigated electrochemical impedance (EIS), methanol permeability, fuel cell performance, and durability. Adding both 1 wt% of CHP and 0.05 wt% functionalized GO into the Nafion membrane, resulting in a 1.86-fold higher durability than that of recast Nafion. In addition, the maximum power density of the composite membrane was 1.34-fold higher (75.41 mW/cm2) than that of the recast Nafion (56.11 mW/cm2) at 1 M methanol and 70 °C. At 2 M methanol and 70 °C, the maximum power density of the composite membrane increased to 80.19 mW/cm2 but then decreased to 46.00 mW/cm2 when the methanol feed increased to 4 M, due to the large amount of methanol crossover.