A study of the removal of selenite and selenate from aqueous solutions using a magnetic iron/manganese oxide nanomaterial and ICP-MS

Selenium (Se) is naturally occurring in the environment and is an essential nutrient in mammals. However, environmental Se can be increased to toxic levels through different industrial practices. The potential adsorption of the Se oxoanions, selenite and selenate, from aqueous solutions onto nanosynthesized MnFe2O4 was investigated using batch techniques and DRC-ICP-MS spectroscopy. The nanomaterial (NM) was laboratory synthesized through slow titration of a mixture of Fe2+ and Mn2+ ions. X-ray diffraction and Scherrer's equation were used to determine the phase of the material and crystallite size, respectively. The effects of pH, reaction time, competitive anions, and the adsorption capacity of the synthesized NM to bind selenite and selenate were investigated. The Langmuir isotherm was used to determine the binding capacity of the NM. Results showed that the phase of the nanomaterial was similar to Jacobsite with a size of 27.5 nm. Results also showed that the sorption of either 100 ppb of selenite or selenate was pH independent in the pH range 2 to 6 and occurred within 5 min of contact time. The introduction of Cl− and NO3− anions individually added to solution had no significant effect on the sorption of either selenite or selenate. However, it was found that the addition of SO42− had a competitive effect only on the sorption of selenate, first seen at 10 ppm and more pronounced at 100 ppm of SO42−. In the presence of 100 ppm of PO43−, the adsorption of selenate decreased to 87% while selenite sorption decreased to 20%. From the Langmuir isotherm equation it was determined that the nano-Jacobsite had a selenite and selenate binding capacity of 6573.76 and 769.23 mg Se/kg of NM, respectively.