An experimental study on the in situ strength of SiC fibre in unidirectional SiC/Al composites

In order to investigate the effect of strain rate and high temperature exposure on the mechanical properties of the fibre in the unidirectional fibre reinforced metal-matrix composite, in situ SiC fibre bundles are extracted from two kinds of SiC/Al composite wires, which are heat-treated at two different temperatures (exposed in the air at 400 and 600 °C for 40 min after composition). Tensile tests for these two fibre bundles are performed at different strain rates (quasi-static test: 0.001 s−1, dynamic test: 200, 700, and 1200 s−1) and the stress–strain curves are obtained. The experimental results show that their mechanical properties are rate-dependent, the modulus E, strength σb and unstable strain εb (the strain corresponding to σb) all increase with increasing strain rate. Compared with the mechanical properties of the original SiC fibre, those of the two in situ fibres degrade to some extent, the degradation of the in situ fibre extracted from the composite wire exposed at 600 °C (hereafter referred to as in situ fibre 2) is more serious than that of the in situ fibre extracted from the composite wire exposed at 400 °C (hereafter referred to as in situ fibre 1). The mechanism of the degradation is investigated. A bi-modal Weibull statistical constitutive equation is established to describe the stress–strain relationship of the two in situ fibre bundles. The simulated stress–strain curves agree well with the experimental results.