Supported molybdenum oxides for the aldol condensation reaction of acetaldehyde

• Reduced MoO x sites on supported catalysts are active for aldol condensation. • Pretreatment conditions do not influence steady state aldol condensation activity. • Lewis acid site strength and density are relevant properties. • Moderate/strong acid sites are needed to activate carbonyls for aldol condensation. • MoO x interacts strongly with Al 2 O 3 support and weakly with SiO 2 support. The (retro-)aldol condensation reaction is an important chemical transformation in the upgrading of biomass-derived compounds into fuels and valuable specialty chemicals. In this study, we found that supported molybdenum oxide (MoO x ) catalysts were active and selective for the aldol condensation of acetaldehyde to crotonaldehyde under steady-state reactor conditions. Through a combination of transmission electron microscopy (TEM), ultraviolet–visible (UV–VIS) diffuse reflectance spectroscopy, Fourier transform infrared (FTIR) spectroscopy of adsorbed pyridine , and steady-state reactor testing, we determined that highly dispersed MoO x has a strong interaction with a γ-Al 2 O 3 support resulting in optimal catalyst performance at low weight loadings. In contrast, MoO x particles supported on SiO 2 have a weaker interaction with the support, resulting in a monotonic relationship between Mo loading and aldol condensation activity. The Lewis acid site density and strength are important parameters for predicting aldol condensation activity across all samples. The concentration of weak acid sites had a poor correlation with aldol condensation activity, most likely because these sites are too weak to activate acetaldehyde for the reaction. Medium and strong acid sites both had good correlations to aldol condensation activity. Results from X-ray absorption near edge structure (XANES) and acetaldehyde temperature programmed desorption (TPD) indicated that partially reduced MoO x was more active for aldol condensation, but pretreatment in reducing or oxidizing environments had no significant effect on steady-state catalytic activity. Characterization of spent catalyst samples through temperature programmed oxidation (TPO) and thermogravimetric analysis (TGA) revealed that catalysts with high densities of strong acid sites tended to form more carbonaceous deposits on the surface over the course of the reaction.