Stiffness Modifiers to Support the Seismic Design of Reinforced Concrete Rectangular Columns

Stiffness modifiers are used in linear structural analysis programs to recognize the low-strain amplitude nonlinear material stress–strain response and support the design of reinforced concrete structures. For example, stiffness modifiers are used to account for the reduction in stiffness that results mainly from crack development and propagation, bar bond slip between cracks, and bar bond slip of the longitudinal reinforcement developed beyond the column ends. This paper presents a primarily mechanistic model to compute the stiffness modifiers for reinforced concrete rectangular columns to support the seismic design of reinforced concrete structures. The model accounts for five modes of deformation found in columns and is calibrated against a database of test results reported in the literature on 38 large-section columns that exhibited ductile response. The paper also describes a simplified equation for use in seismic design. The simplified equation was calibrated through an extensive parametric analysis of the model. The mean, median and coefficient of variation of the ratios of the stiffness modifiers computed from the recorded response of test columns and the model output were 1.02, 1.00, and 0.18, respectively, and those calculated by the simplified equation for the same ratios were 0.95, 0.98, and 0.18, respectively.