Surface integrity of Ti-6Al-4V alloy in hybrid electrical discharge machining processes

Titanium alloy is one of the difficult-to-machine materials. The final conditions of the machined surface of this alloy are influenced by electro-discharge machining. High temperatures and thermal cycles in machining operation induce undesirable alterations in the surface quality of Ti-6Al-4V. One of the ways to improve the negative effects of electrical discharge machining is to use hybrid methods. There is no comprehensive research on the effect of hybrid electrical discharge machining process on the surface integrity of the Ti-6Al-4V alloy. In this paper, hybrid electrical discharge machining techniques including ultrasonic-assisted electrical discharge machining, powder-mixed dielectric electrical discharge machining using Al 2 O 3 nanopowders and powder-mixed dielectric combined with ultrasonic-assisted electrical discharge machining, were used for processing of this alloy. The hybrid electrical discharge machining processes were evaluated by basic specifications of surface integrity including surface cracks, heat affected area, residual stress, and corrosion resistance. It was found that in powder-mixed dielectric combined with ultrasonic-assisted electrical discharge machining process, developed microcracks were very low and this process developed a thinner heat-altered layer, compared to traditional electrical discharge machining process, which produced a thicker heat-altered layer. The findings also, demonstrated that ultrasonic waves have reduced residual stresses compared to other methods and its stress diagram was distinct in comparison with the other processes. The corrosion rate of samples machined by electrical discharge machining process was higher than other hybrid processes; in powder-mixed dielectric electrical discharge machining process, the machined samples had the highest corrosion resistance.