Horizontal ridge augmentation using guided bone regeneration with an association of particulate allografts mixed with platelet-rich fibrin, collagen membrane and tent-screws: A prospective study

Guided Bone Regeneration (GBR) is a versatile technique employed not only to correct pre-implant alveolar bone defects but also to facilitate bone defect correction during simultaneous implant placement. The effectiveness of GBR varies significantly among different protocols, as reported in the literature. This study specifically aimed to radiologically evaluate the horizontal bone gain obtained using a GBR procedure combining a particulate allograft, platelet-rich fibrin, resorbable collagen membrane, and screw tents. A total of 42 patients with an insufficient alveolar bone width for dental implant placement were treated with a GBR technique using a mixture of particulate allograft (demineralised freeze-dried bone allograft 300–500 and 500–1000 µm), advanced platelet-rich fibrin (A-PRF), resorbable collagen membranes and screws tents (1.2 mm in diameter). Over the course of the study, a total of 63 GBR procedures were performed on these patients. Bone gains were measured by cone-beam computed tomography at 9.1 ± 2.0 months post-operative. A significant mean increase (P < 0.001) of 3.2 ± 0.9 mm at the sites of the greatest bone defect was observed. This improvement was consistent across various locations, including both maxillary and mandibular regions, and in cases of terminal and embedded edentulism, without any post-operative complications during the entire post-operative follow-up. All patients benefited from implant placement following the bone augmentation protocol. GBR combining particulate allografts, A-PRF, collagen membranes, and screw tents achieves reliable, predictable, and reproducible clinical gains that allow for future implant placement.