A novel method for ball forming by cross wedge rolling

In this paper, a novel method for ball forming by cross wedge rolling (CWR) was proposed, and the finite element (FE) simulation and experimental verification were carried out with the 26 mm diameter steel ball as an example. First of all, the die parameters including spreading angle β and forming angle α were selected and the 3D models of the die and guide plate were designed. Then, the FE model was established and preliminary simulation was carried out using the Simufact 16.0 software. The preliminary simulation results showed that the pushing empty defect occurred in the process due to lack of transition from spreading stage to sizing stage and conical die section. Modifying the die design by adopting the method of adding transition spreading angle θ and forming angle α ´ increasing with the increase of rolling depth to, the defect could be eliminated and the full filling can be obtained. In addition, the simulation analysis after modified also included effective strain and stress distribution, the kinematic analysis of metal flow, the damage distribution based on the Cockcroft-Latham criterion, the temperature evolution and force parameters in the CWR process. Finally, the rolling experiments and radial rolling force testing experiments were carried out to verify the numerical results. The results indicated that the FE simulation results were consistent with the experimental results through quantitative analysis, which proved that the novel method for ball forming by CWR was feasible simultaneously.