Dimensional stability and mold resistance of bamboo slivers treated by alkali

The aim of this study was to investigate the dimensional stability and mold resistance of slivers from the outer and inner layers of bamboo treated with alkali solutions at various concentrations. The microstructure of the bamboo slivers considerably changed as the parenchyma cells collapsed after alkali treatment followed by a drying process. The water absorption of the treated bamboo slivers increased, while the dimensional stability decreased, especially for the slivers from the inner layer of bamboo. The alkali treatment removed starch from the parenchyma cells in the bamboo slivers treated with a 2% to 15% alkali solution, resulting in a considerable improvement in the mold resistance. The mold resistance performance of inner bamboo slivers was greatly improved when treated at a low concentration (2%). No mold on the bamboo slivers was found even in a high humidity environment for a long period of time, i.e. 87 days. As the concentration increased up to 25%, alkali only removed starch from parenchyma cells that were near the surface of the bamboo slivers and caused partial damage to the parenchyma cells in the outer bamboo slivers. The wettability of the alkali-treated bamboo slivers was higher than that of the untreated samples due to the removal of lignin and a rougher surface. Based on the test results, alkali treatment is a simple yet highly effective method for improving mold resistance but would cause a reduction in the dimensional stability of the bamboo slivers.