Narrow linewidth semiconductor DFB laser with linear frequency modulation for FMCW LiDAR

Monolithic distributed feedback semiconductor lasers (1550 nm) for FMCW LiDAR applications have been designed, fabricated and tested. The strong optical frequency modulation distortion observed when a standard DFB laser is modulated with a triangular current waveform is significantly mitigated in our laser. A 100 kHz frequency modulation with amplitude of 0.9 GHz and nonlinear distortion of 0.3%, calculated as the standard deviation of the optical frequency after removal of a linear fit, was measured through an unbalanced fiber interferometer. This was achieved without electronic pre-distortion of the triangular waveform. The 60 kHz intrinsic linewidth of the laser was unaffected by the modulation. Two lasers were co-packaged in a 2.6 cm³ multi-layer ceramic package and coupled to fiber pigtails with micro-lenses. The pins of the ceramic package were soldered to a printed circuit board containing the current sources driving the lasers. This optical source was used in a two-channel LiDAR demonstrator built from off-the-shelf fiber optic components and a twodimensional gimbal scanning mirror. This demonstrator enabled detecting a target with 10 % Lambertian reflectivity up to a distance of >120 m and recording point clouds of different scenes. This shows that FMCW LiDAR in combination with highly coherent and linear DFB laser sources is a very promising technology for long range sensing. A version under development will include a silicon photonics chip for further integration and functionality including I/Q detection.